--- loncom/html/adm/help/tex/Course_User_Parameter.tex 2003/07/14 20:36:23 1.1
+++ loncom/html/adm/help/tex/Course_User_Parameter.tex 2005/06/19 17:58:59 1.4
@@ -1,15 +1,16 @@
\label{Course_User_Parameter}
-To set the course parameters for a selected user, do the following:
+To set the course parameters for a selected user, it is recommended that you use the Parameter Helper. However, if you need to use the Table Mode, then do the following:
\begin{itemize}
\item Click \textbf{PARM} on the remote control.
+\item Click on the link to use the \underbar{Table Mode}.
\item At the \textbf{Set Course Parameter} screen, type the
\textbf{username} or \textbf{id} of the desired user. If you do not
know the username or id, then click the \textbf{Select User} link.
\item Select the \textbf{Parameter level} from the pull down menu. (See discussion
-of parameter levels in \ref{Course_Parameter_Levels}.)
+of parameter levels in \ref{Course_Parameter_Table_Mode}.)
\item Select the enclosing map or folder from the pull down menu. If you choose
course level you will skip this step.
\item Click \textbf{Set Course Assessment Parameters}.
@@ -32,7 +33,7 @@ users in the course. Repeat the previous
\begin{itemize}
-\item Within the \textbf{User ____ at Domain ____} column, click on the "\textbf{-}" for the
+\item Within the \textbf{User \_\_\_\_ at Domain \_\_\_\_} column, click on the "\textbf{-}" for the
parameter setting you want to assign. A new window will open.
\item Update the selected parameter.
\item Click \textbf{Store}.