--- doc/build/RHEL8_install.frag	2019/10/07 18:22:20	1.2
+++ doc/build/RHEL8_install.frag	2024/08/10 02:44:49	1.7
@@ -96,9 +96,9 @@ web server ports (i.e., http and https):
 <pre>
 systemctl enable firewalld
 systemctl start firewalld
-sudo firewall-cmd --zone=public --permanent --add-service=http
-sudo firewall-cmd --zone=public --permanent --add-service=https
-sudo firewall-cmd --reload
+firewall-cmd --zone=public --permanent --add-service=http
+firewall-cmd --zone=public --permanent --add-service=https
+firewall-cmd --reload
 </pre>
 
 <h2>4. <a id="upd">Update your system</a></h2>
@@ -204,7 +204,7 @@ reboot
 <h3>Install prerequisites</h3>
 <p> Execute: </p>
 <pre>
-yum install LONCAPA-prerequisites
+dnf install LONCAPA-prerequisites
 </pre><p>
 This may take some minutes due to LON-CAPA's large number of dependencies.
 </p>
@@ -235,7 +235,7 @@ used to check the configuration of a sys
 </p>
 <p>
 The script will analyze your system to determine which actions are recommended.  The script will then prompt you to choose the actions you would like taken.
-Once a choice has been entered for all nine possible actions, required changes will be made.
+Once a choice has been entered for all ten possible actions, required changes will be made.
 </p>
 <p>The possible actions are:</p>
 <ul>
@@ -244,6 +244,7 @@ Once a choice has been entered for all n
 <li>Set-up the MySQL (Mariadb) database</li>
 <li>Set-up MySQL (Mariadb) permissions</li>
 <li>Configure Apache web server</li>
+<li>Configure systemd security settings for Apache web server</li>
 <li>Configure start-up of services</li>
 <li>Check firewall settings</li>
 <li>Stop services not used by LON-CAPA,  e.g., services for a print server: cups daemon</li> 
@@ -327,7 +328,7 @@ The LON-CAPA network services take a mom
 will be apparent at this step.
 </p>
 <pre>
-/etc/init.d/loncontrol start
+/home/httpd/perl/loncontrol start
 systemctl start httpd
 </pre>
 <p>
@@ -335,7 +336,7 @@ If you receive warnings about missing pe
 please make sure that the LONCAPA-prerequisites rpm is installed using this command:
 </p>
 <pre>
-rpm -q LONCAPA-prerequisites rpm
+rpm -q LONCAPA-prerequisites
 </pre>
 <p>
 If it is not installed, ensure that the required Linux repositories are enabled (see